Hardware Contents
(12) 8mm Flange Head Bolt
(4) 8mm Steel Lock Flange Head Bolt
(2) 12mm Socket Cap Bolt
(2) 12mm Flat Washer
2024 Model (4) 10mm Metric Hex Flange Bolt
- Begin by locating the (2) 12mm cap screws and the (2) 12mm flat washers. They are a 12mm Socket Cap Bolt
- Fit the bolt-on up to the rear of the Roxor
- Loosely install the (2) 12mm cap bolts into the holes above the hitch
- Locate (8) of the 8mm flange head bolts
- Loosely install these bolts into the threaded holes
- Locate the remaining (4) 8mm flange head bolts and steel lock nuts. Install these into the last 4 remaining holes

- Once all the bolts are loosely fastened, you may tighten up all bolts and nuts.
M12 = 105 lb-ft (black bolts)
M10 = 60 lb-ft (only 2024 model)
M8 = 30 lb-ft

- If you have 2024 model use 10mm metric hex flange bolts on the (4) outer holes, you’ll have (4) extra of the 8mm flange head bolts. You may discard them.
